Superelevation of Road Curves: Influence on Vehicles Fuel Consumption
Authors
-
Alex Coiret
*
Structure et Instrumentation Intégrée (SII) Laboratory, Composants et Systèmes (COSYS) Department, Université Gustave Eiffel, 44340 Bouguenais, France
-
Pierre-Olivier Vandanjon
Systèmes Productifs, Logistique, Organisation des Transports et Travail (SPLOTT) Laboratory, Aménagement, Mobilités et Environnement (AME) Department, Université Gustave Eiffel, 44340 Bouguenais, France
DOI:
https://doi.org/10.55121/tdr.v4i1.1052Abstract
Transport systems are primarily designed to address mobility and safety concerns. Today, energy consumption must also be taken into account in infrastructure design and operation, as environmental issues and tensions in oil production continue to intensify. For road transport, infrastructure requires energy for its construction, maintenance, and use. During the use phase, previous studies have assessed the influence of road texture, longitudinal slopes, and curvature on vehicle consumption. In this study, superelevation in curves is investigated as an additional parameter that may affect vehicle energy consumption. This investigation is first introduced using a simplified two-wheel model, showing a computed reduction in rolling resistance of 3% to 9% depending on cases. Full-scale experiments were then conducted using similar parameter ranges, with an instrumented passenger car on a curved road section featuring a continuous crossfall varying from 0 to 40%, and at three travel speeds: 80, 110, and 120 km/h. Experimental measurements confirm the numerical approach, with consumption reductions of up to 10% achieved for a light vehicle on a curve with optimal crossfall. The aim of this research is not to promote the design of all roads with high superelevation, which could be unsafe in most cases, but rather to contribute empirical knowledge to refine numerical consumption models. However, in specific situations such
as high-speed highways, intermediate or high crossfall could be considered, provided that appropriate driver warnings are implemented or that advanced driving assistance systems become widespread. Future perspectives are discussed, taking into account other road requirements such as safety
Keywords:
Roads, Use Phase, Energy Consumption, Design, Crossfall, VehiclesReferences
[1] SETRA, 2000. ICTAAL: Instruction on the Technical Conditions for the Development of Connecting Highways. SETRA: Bagneux, France. pp. 1–58. Available from: https://dtrf.cerema.fr/pdf/pj/Dtrf/0002/Dtrf- 0002540/DT2540.pdf (in French)
[2] Esposito, T., Mauro, R., Russo, F., et al., 2011. Speed prediction models for sustainable road safety management. Procedia Social and Behavioral Sciences. 20, 568–576.
[3] Baptista, P.C., Silva, C.M., Farias, T.L., et al., 2012. Energy and environmental impacts of alternative pathways for the Portuguese road transportation sector. Energy Policy. 51, 802–815.
[4] Monzon, A., Sobrino, N., Hernandez, S., 2012. Energy and Environmentally Efficient Road Management: The Case of the Spanish Motorway Network. Procedia - Social and Behavioral Sciences. 48, 287–296.
[5] Blanc, J., Hornych, P., Sotoodeh-Nia, Z., et al., 2019. Full-scale validation of bio-recycled asphalt mixtures for road pavements. Journal of Cleaner Production. 227, 1068–1078.
[6] Jiang, R., Wu, P., 2019. Estimation of environmental impacts of roads through life cycle assessment: A critical review and future directions. Transportation Research Part D: Transport and Environment. 77, 148–163.
[7] Araújo, J.P.C., Oliveira, J.R., Silva, H.M., 2014. The importance of the use phase on the LCA of environmentally friendly solutions for asphalt road pavements. Transportation Research Part D: Transport and Environment. 32, 97–110.
[8] Stripple, H., 2001. Life Cycle Assessment of Road; A Pilot Study for Inventory Analysis. IVL Swedish Environmental Research Institute: Stockholm, Sweden.
[9] Mukhopadhyay, K., Forssell, O., 2005. An empirical investigation of air pollution from fossil fuel combustion and its impact on health in India during 1973–1974 to 1996–1997. Ecological Economics. 55(2), 235–250.
[10] Coiret, A., Vandanjon, P.O., Bosquet, R., et al., 2012. Energy consumption induced by operation phase of railways and road infrastructures. In Proceedings of the 2nd International Conference on Road and Rail Infrastructure, Dubrovnik, Croatia, 7–9 May 2012.
[11] Roumegoux, J.-P., 1995. Calcul des émissions unitaires de polluants des véhicules utilitaires. Science of The Total Environment. 169(1–3), 205–211.
[12] Ciarla, V., Chasse, A., Moulin, P., et al., 2016. Compute Optimal Travel Duration in Eco-Driving applications. IFAC-PapersOnLine. 49(11), 519–524.
[13] Coiret, A., Vandanjon, P.O., Cuervo, A.T., 2016. Ecodriving potentiality assessment of road infrastructures according to the adequacy between infrastructure slopes and speeds limits. In Proceedings of the 4th International Conference on Road and Rail Infrastructure (CETRA 2016), Sibenik, Croatia, 23–25 May 2016; pp. 589–595.
[14] Kang, M.W., Shariat, S., Jha, M.K., 2013. New highway geometric design methods for minimizing vehicular fuel consumption and improving safety. Transportation Research Part C: Emerging Technologies. 31, 99–111.
[15] Sentoff, K., Aultman-Hall, L., Holmén B., 2015. Implications of driving style and road grade for accurate vehicle activity data and emissions estimates. Transportation Research Part D: Transport and Environment. 35, 175–188.
[16] Consolini, L., Laurini, M., Locatelli, M., 2026. A convex reformulation for speed planning of a vehicle under the travel time and energy consumption objectives. Automatica. 185, 112811. DOI: https://doi.org/10.1016/j.automatica.2025.112811
[17] Song, J., 2025. Evaluation of driving resistance and energy consumption in electric vehicles under various ambient and tire temperatures using real-world driving data. ETransportation. 25, 100454. DOI: https://doi.org/10.1016/j.etran.2025.100454
[18] Gao, C., Xu, J., Jia, M., et al., 2024. Correlation between carbon emissions, fuel consumption of vehicles and speed limit on expressway. Journal of Traffic and Transportation Engineering (English Edition). 11, 631–642. DOI: https://doi.org/10.1016/j.jtte.2023.02.007
[19] Dixon, J.C., 1996. Tires, Suspension, and Handling, 2nd ed. Society of Automotive Engineers: Warrendale, PA, USA; Arnold: London, UK.
[20] Burgess, S.C., Choititle, J.M.J., 2003. A parametric study of the energy demands of car transportation: A case study of two competing commuter routes in the UK. Transportation Research Part D: Transport and Environment. 8(1), 21–36.
[21] Kang, M.W., Jha, M.K., Schonfeld, P., 2012. Applicability of highway alignment optimization models. Transportation Research Part C: Emerging Technologies. 21(1), 257–286.
[22] Jin, X., Xiao, X., Wen, Z., et al., 2009. An investigation into the effect of train curving on wear and contact stresses of wheel and rail. Tribology International. 42(3), 475–490.
[23] Wang, J., Chen, X., Li, X., et al., 2015. Influence of heavy haul railway curve parameters on rail wear. Engineering Failure Analysis. 57, 511–520.
[24] De Angelo, M., D’Ovidio, G., 2021. Lateral displacement evaluation for a high-Temperature superconducting magnetic levitation experimental vehicle running over a banked curvilinear path. Physica C: Superconductivity and Its Applications. 591, 1353974.
[25] Vandanjon, P.-O., Coiret, A., Lorino, T., 2014. Application of viability theory for road vehicle active safety during cornering manoeuvres. Vehicle System Dynamics. 52(2), 244–260.
[26] Orfila, O., Coiret, A., Do, M.T., et al., 2010. Modeling of dynamic vehicle–road interactions for safety-related road evaluation. Accident Analysis and Prevention. 42, 1736–1743.
Submit Manuscript
